![]() ![]() Sorry with the confusion with steps d and e, they should read 5 and 6Well, you've changed tactics since the first time. I drew the line after I reset the units to meters using -DWGUNITS, read my post no. Scale objects in current drawing to reflect change in units? : y I repeated the whole process this timeĪnswering Y to Include objects in Paper Space? but again no luck. 2 units long in model spaceĮ.) set the viewport scale to 1:1 in layout1 and observe my line Here's precisely the steps I take:Ģ.) open a fresh acadiso.dwt template fileģ.) define a paper setup for layout1, paper set to 8½x11 landscapeĤ.) run -DWGUBITS command line (readout is below)ĭ.) draw a line. I must be incredibly dense but I can't get it to work. Include objects in Paperspace? how did you respond to that? Scale objects in current drawing to reflect change in units? : y>:YesĪfter everything you showed, there was another question at your commandline, ** existing objects will not change size unless you specifically ** ** All new objects will be drawn according to the new unit, but ** ![]() ** WARNING: you have changed the unit for this drawing database. Scale objects from other drawings upon insert? : y It seems no matter what I try paperspace can only see millimeters as the drawing units My model space units still get drawn as mm inside a 1:1 paperspace viewport. I ran -DWGUNITS and switched out of mm and into m but it still doesn't work. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |